The COR-ACC940 Wiegand proximity cardreader is an advanced access control device in a grey ABS case that uses a built-in bicolored LED and beeper to provide users with a visual and audible indication that a card has been scanned.
It can operate in standalone mode or in networking configurations.
This indoor proximity card reader works great and has an LED to indicate positive card read, and a buzzer. Great for interior doors and areas where access must be monitored or controlled.
Best when used with our controller, COR-ACC1000
Built-in watchdog function prevents system lock-up. Sealed for outdoor use.Attached cable and plug connector make installation simple.
Main Features
- Indoor/Outdoor design
- Tamper switch
- Construction ABS plastic
- Bi-color LED (Red/Green),one beeper
- Gray finish
- Communication interface: RS-485, TTL Wiegand, ABA-IIC
- Baud rate: 9600 bps (N,.8,1)
- Data format: RS232
- Maximum # users :
- 65,536 (card only)
- 1024 using combination of card and PIN (using attached controller or peripheral keypad)
- Indicators: Bi-color LED ( Red/Green), 1 beeper
- Placement: Indoor or outdoor ( sealed construction)
- Anti-pass back: multi-door when used with COR-ACC1000
- Remote operation supported when used with COR-ACC1000
- Wiegand output: WG26, WG34, ABA-II (by WG mode only)
- Request to exit: supported
- Reader range: 10- 20cm at 125kHz, 3-8 cm at 13.56MHz
- DO inputs: Door output and alarm output
- Made of ABS plastic
- nPower consumption: <1.5W
- Input voltage: 9-16VDC or 9-24VDC for 13.56MHz operation
- Dimensions (mm):
- 113mm (L) 71 mm (W) 36mm (H)
- Dimensions (inches):
- 3.18inches (L) 1.69 inches (W) 0.71 inches (H)
- Operating temperature: -20 ˚ C to +75 ˚ C (-4 ˚ F to + 167˚ F)
- Temperature/humidity: -10 C - 50 C (14 F - 122 F) @ 0-90% relative humidity non-condensing
- Weight: 80g (+/-10g)