The COR-ACC950 proximity card reader is an advanced access control device in a weather-proof case that uses an LCD panel and LEDs to provide users
with a visual indication that a card has been successful scanned. A beeper provides audio feedback. It can operate in network or standalone mode ( detects mode automatically).
Control mode, card capacity and card type are assignable by user directly. Maximum distance is approx. 18 cm (7 inches), depending on weather conditions and setup. Constructed of tough ABS plastic and sealed against the weather.
This advanced card reader is designed for outdoor placement and contains a door control relay. It's resistant to vandalism and has many extra features that make it a great addition to any private or public access control network.
Constructed of tough aluminum alloy.
Best when used with our controller, COR-ACC1000
Main Features
- Big and clear LCD display
- >Up to 120 holiday schedules
- Made of ABS plastic
- Indoor/outdoor design
- Big and clear LCD display, 4 lines text, 1024 x 64 pixel graphic
- Unlimited site codes
- 11 sets of time zones
- Different time zone for each user
- Up to 120 holiday schedules
- Auto-show work status (set via time zone edit)
- Master cards range assignable
- RS-485 support for networking (via controller or directly)
- Built-in door sensing and arming inputs (on/off)
- Auto open/close scheduling of doors
- Control mode, card capacity and card type assignable by user directly
- Built-in proximity reader and external Wiegand reader port
- Auto-discriminating between stand-alone & networking system
- Alarm function available (tamper, force entrance, door sense)
- Networking: RS-485, 9600, N, 8, 1
- External reader port: Suitable for all WG, ABA reader, 125K, 13.56M (Mifare) or 2.4G reader
- RF Frequency / Reading range 125 kHz / 10-18cm
- Door relay: 12VDC @ 2A NO/NC/COM 0.1-600 sec. latch type
- Alarm relay: 12VDC @ 2A NO/NC/(jumper) 0.0-600 sec. (COM Common)
- DI input: Egress button / door sensor / card sensor
- Transistor output: Arming / door sensor / card sensor
- Tamper switch limit switch (form C)
- Serial port: supported for AI-401R016, LED display, relay board, printer ETC. (4800, N, 8, 1)
- Made of ABS plastic
- Dimensions: 127mm x 91mm x 46mm (5" x 3.58" x 1.81")
- Connects easily to our COR-ACC1000
- Connect to PC using COR-CN560